Inacks
  • Welcome to the IS4310 Modbus Chip Wiki
  • Datasheet
    • Presentation
    • Description
      • Function Codes
      • Exception Codes
      • IS4310 Advantages
      • Modbus UART Port
    • Pin Description
    • Memory Description
      • Memory Map Table
      • HOLDx Registers
      • MBADR Register
      • MBBDR Register
      • MBPAR Register
      • MBSTP Register
    • I2C-compatible Bus Description
      • Single Word Read
      • Multiple Word Read
      • Single Word Write
      • Multiple Word Write
  • Hardware Examples
    • RS485 Design Example
    • Isolated RS485 Design Example
    • Bus Topology
    • Cable Wiring
  • Firmware Examples
    • Arduino Example
    • STM32 Reading Example
    • STM32 Writing Example
  • Appendix
    • Mechanical Drawings
    • Ordering
    • Product Selection Guide
    • Documentation Feedback
    • Customization
    • Legal
Powered by GitBook
On this page
  1. Hardware Examples

Bus Topology

PreviousIsolated RS485 Design ExampleNextCable Wiring

Last updated 20 days ago

In an RS485 setup without a repeater, a single trunk cable runs through the system, with devices connected in a daisy-chain manner. Short cables derivations (stubs) are also allowed but not recommended. Keep the derivation distance as short as possible. Other topologies are not allowed.

IS4310 RS485 Bus Topology